1.　風機答應全壓起動或降壓起動，但應留意，全壓起動時的電流約為5~7倍的額定電流，降壓起動轉距與電流平方成正比，當電網容量不足時，應采用降壓起動。（當功率大于11KW時，宜采用降壓起動。） 

　　2.　風機在試車時，應當真閱讀產品仿單，檢查接線方法是否同接線圖相符；應當真檢查供應風機電源的工作電壓是否符合要求，電源是否缺相或同相位，所配電器元件的容量是否符合要求。 

　　3.　試車時人數不少于兩人，一人控制電源，一人觀察風機運轉情況，發現異常現象立刻停機檢查；首先檢查旋轉方向是否準確；風機開始運轉后，應立刻檢查運轉電流是否平衡、電流是否超過額定電流；若不有正常現象，應停機檢查。運轉五分鐘后，停機檢查風機是否有異常現象，確認無異常現象再開機運轉。 

　　4.雙速風機試車時，應先起動低速，并檢查旋轉方向是否準確；起動高速成時必需待風機靜止后再起動，以防高速反向旋轉，引起開關跳閘及電機受損。 

　　5.風機達到正常轉速時，應檢測風機輸入電流是否正常，風機的運行電流不能超過其額定電流。若運行電流超過其額定電流，應檢查供應風機的電壓是否正常。 

　　6.風機所需電機功率是指在一定工況下，對離心風機和風機箱，進風口全開時所需功率較大。若進風口全開進行運轉，則電機有損壞的可能。風機試車時最好將風機入口或出口管路上的閥門封閉，運轉后將閥門徐徐開啟，達到所需工況為止，并留意風機的運轉電流是否超過額(e)定電流。